Inner fork tubes stuck

so im trying to disassemble my fork tubes completely, and ive gotten the spring, bottom bolt and dampener rod out but when i try to pull out the inner tubes i hit a sort of bump, the pull out id say 95 percent of the way but then it stops. Ive removed the upper seal, o ring, and the bushing from the tubes but im unsure if there is any more to remove. If it help its the anti dive fork system

Hope you guys can help
Proar

Yamaha xj750 seca 1983 uk

 

And you have removed the spring clip under the dust seal that holds the oil seal ? Then it should pull out with a few pulls of the tube. Some times it requires a few hard pulls to get bushing to pop out

 

The spring clip is out to. Spoke with my mechanic today and he also said it might be a bushing. I gues im just a bit nervous of being too rough

 

The tube acts sort of like a slide hammer to drive it out from the inside.

 

so before i go and do something stupid i need to be clear. mild violence is actually the answer for once?

 

Yes.
So long as this

Which somtimes looks like this


Has been removed.

 

Mild violence?!
Is that like no more than 3 cuss words per fork?

 

Seriously? People get by with just that?

 

If you end up being mildly violent watch out for a couple of VERY thin washers near the bottom of the fork, there's a pic of them in this link about 1/2 way through page 1
http://xjbikes.com/forums/threads/doing-the-750-secas-forks-rebuild-now-a-how-to.18730/

also a pic in this one http://xjbikes.com/forums/threads/fork-rebuild-for-1982-seca-xj750rj.42006/

 

I got them of yesterday so yeah mild violence for president!

 

+1.Good job.Inspect the entire front braking system and wheel/tire while you're there.

Gary H.