XJ and quite frankly, cycle noob.....

Oh boy.... Lemme figure that out lol. Thanks K-Moe! Feeling better?

 

I just use youtube and throw the link here.

 

Lungs are officially clear. My head's still a bit stuffy, but that's just a minor detail.

 

Put the headlamps brackets and front turns on today to see how it all fit......


I need to buy a real camera or replace this phone.... She's getting shaky. Old Galaxy s3 on its 3rd screen, 5th gps antenna repair, and 2nd audio jack lol. Sorry for the blur.

 

It was just a short video of some really bright leds in the proto board with resistors, diodes, and a switch to simulate tail and brake light.... I also got my acrylic rod today. i want to play with the optics in the tail cone. I like the idea of being visible from a distance (that and as a child I was nuts over the film Tron. So there will be a bit of influence there).

 

That being said, I like that idea Dave. It's time for me to come out of my cave lol. My better half's daughter has a go pro and she expressed interest in filming the bike some when it's done.

 

Nice work. With the headlight bucket mounted upside down it may effect the beam comes from the light.

 

i notched the bezel to relocate the alignment tabs. The headlamp is right side up. You'd be able to see it if my phone didn't make me look like i wake up to a pot of coffee LOL!

 

I do however wake up to green tea and smokes

 

WOO HOO!!! I'm like you, ever since my back blew out and I was "installing" my socks with long needle nose pliers for an hour every morning, my current limp and occasional "lightning bolt' down one leg or another, is a very minor detail!

 

Wow, the socks thing is too close to home. (not anymore, but just a month ago).

 

I take it you are a card carrying member of the sciatica club?

 

Inversion table.

 

I hang from a chin-up bar.... upside down messes with the pressure in my head. Ears and Sinuses. But it is amazing on the spine.

 

make your life simple , get rid of the socks

 

LMAO!!!! Then my feets get cold!

 

Got my bars......Finally got the position right. I could ride these for hours. Only slightly aggressive. But 6061 T6 Aluminum. I have a feeling I'll need the bar end mirrors that dampen vibration...

 

http://www.ebay.com/itm/YAMAHA-GAS-...ash=item25cc5cac60:g:iq8AAOSw44BYacUJ&vxp=mtr

Somebody was recently asking me about tank emblems.... Here's a pair on ebay that dont look hateful.

 

Fill the bars with butylene rubber caulk. That will reduce the high frequency vibrations by quite a lot. Also make sure that you've done a running synch on the carbs. Cylinders that are fighting each other will cause more vibration.

 

Nice!!! I like the way you think! I just happen to have a tube of 3M window weld....