k-moe, I can't remember which one I used the last time I changed oil in the forks, but I'm fairly certain is was Dexron-III rated, which is...
Alternately, you can use ATF. Works great for me. YMMV.
It sounds to me like you have an air leak, which would only require replacement of the o-rings that seal the air valve assembly at the top of the...
Hi guys, Went out last weekend to start getting the bike ready for summer. Set the fuel to prime for a bit, then hit the starter. She fired right...
x2 on cleaning other connections! Also, the correct way to test the switch is with a continuity tester/ohm meter. Should read infinite (open)...
Frame repair isn't difficult, as long as you know what you're doing with the welder. With the relatively thin wall tubing used though, it's also...
Just thinking out loud, but have you tried setting the petcock to prime to see if the problem goes away?
Hi guys, I had a Patriot Guard mission today. I fired up the bike yesterday just to make sure it was gonna run, and #1 was dead cold. Fiddled...
Ah, I somehow had it in my mind that this was a Seca 750! Disregard my earlier comment on the headlight swap.
Most likely you'll need to find parts online for the brakes. User "Chacal" on here has treated me very well. Parts may not be as cheap as you can...
What fairing is that!? I like it.
Hi, and welcome to the forum! The rear brakes are easy to check, and replace if necessary. Probably best to buy a manual though, you'll need it...
Howdy, and Welcome!