Sure, why not
I think you could use a little touch up on the MC cover, my personal opinion. [img] But this: [img] Definitely gets you closer to...
The difficulty of the carbs mainly depends on what you're starting with. I started with carbs that were somewhat clean and [i]mostly[/] there.
Decided to sell the 650R. Would like it gone before the weekend. For those of you not familiar with it you can check out my build thread in my...
I believe what jc was referring to was the fact that finding and installing the front brake isn't hard to do.
Cleaned the carbs how? Pretty much a good idea to set float levels and bench sync any time you take them off the bike. I'd start with the...
You have to match engine RPMs to tranny speed. Usually done on an upshift as you roll off the throttle, quickly grabbing a gear, then back on...
It's a very tight fit. The smaller the better. I got a couple of the 90* filters from Len the last time I ordered. [img]
US carbs are commonly jetted differently because of our more stringent EPA regs.
Yup, then save the rest of the spending money until you have enough to buy all the parts for the brake system at once. A tip: If you plan on...
I do put peanuts in my Coke, but I will never put fruit in my beer.
Fitz probably already has the book. He probably has a lot of them. I envision an entire wall of the garage dedicated to nothing but motorcycle...
Thanks, all, for the kind words. I'll have to get with Schmuck and have him edit a note about the bolt needing to be insulated. You're not the...
I'm in.