1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

YICS tool - same dimensions for all engine sizes?

Discussion in 'XJ Technical Chat' started by ryanismyname, Nov 18, 2009.

  1. ryanismyname

    ryanismyname Member

    Messages:
    49
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Baltimore, MD
    I've searched 3 different forums and can't find an answer to this question, yet I'm surprised it hasn't been asked: are the dimensions in the YICS schematic linked here good for all YICS engines? If I can build it for only a few bucks then I'll just make it, but I want to be sure it works on the 750s. If all the YICS engines were 4 cylinders I can see the spacing in the intake being the same but I think Yamaha made a 3 cylinder with YICS, didn't they?

    Wish me luck on my carb rebuild/sync.
     
    ryanismyname, Nov 18, 2009
    #1
  2. chuckles_no

    chuckles_no Member

    Messages:
    660
    Likes Received:
    1
    Trophy Points:
    16
    Location:
    wisconsin
    I used the same tool for my 550 and for my 650... and if you can't find it, I can send you a link on how to make one. But the 550 and 650 were the same... never used it on the 750 but had bought it with the carbs freshly done...
     
    chuckles_no, Nov 18, 2009
    #2
  3. TIMEtoRIDE

    TIMEtoRIDE Active Member

    Messages:
    4,686
    Likes Received:
    11
    Trophy Points:
    38
    Location:
    Clermont FL near Orlando
    It's all the same- - all good. Except the 400 2 CYl is inaccessible, the V2 Vision is different, and the early Venture also had YICS.

    Anyone on a tight budget can stuff it with oily rags for your first sync. You're supposed to clean the port anyway before installing the tool.
     
    TIMEtoRIDE, Nov 18, 2009
    #3
  4. ryanismyname

    ryanismyname Member

    Messages:
    49
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Baltimore, MD
    Much appreciated, TIME.
     
    ryanismyname, Nov 19, 2009
    #4

Share This Page