1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

? about my posible 1980 XJ650 bobber project

Discussion in 'XJ Modifications' started by streetmaster, Nov 29, 2009.

  1. streetmaster

    streetmaster Member

    Messages:
    228
    Likes Received:
    0
    Trophy Points:
    16
    I've been thinkin real hard about bobbin out my XJ650, but had a thought about the drive shaft. It seems as though most projects are limited to the length of the drive shaft.

    I noticed that the drive shaft universal has a flange at the end of it, and it bolts to the flange thats on the back of the motor, popping out of the trans.

    Is it possible to place a spacer between the two flanges of the drive shaft, and the motor, with out a ballance issue?

    It would be nice to gain atleast an inch or two between the tank and tire.
     
    streetmaster, Nov 29, 2009
    #1
  2. 3784rider

    3784rider New Member

    Messages:
    19
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    New Zealand
    chop it up,i like mine now than what it was before.plus it lowers the seat,an extend the swing arm to.
     
    3784rider, Nov 29, 2009
    #2

Share This Page