My 1982 xj550 Bobber project

I'm a little lost with my Bobber project... I got the motor mounted on my stretched frame and i installed my new harness which needs to be lengthened (no big deal). My issue is that I have a few molex connections that are not being used hanging on the harness... I need to know if I have all of the parts on the motor because it looks a lot like there are more connections that are there besides the lights and turn signals, haha. Its very hard to find pictures of my motor outside of a stock frame to compare it to. If anyone can help me out send me a message or post on here and I'll check back in a day or two. Thank you very much for your time

 

what kind of motor is that,i thought thay dint come with chain drive

 

My 550 also has chain drive i think its everything above 550cc

 

There are a number of relays that connect into the harness.

XJ550 models:

Flasher: on a tabbed bracket at the rear of the ignition coils rear mounting bracket.
Flasher canceller: behind ignition coils.
Starter motor solenoid/relay: behind the right side cover, behind the access panel, below the regulator.
Starter/Ignition cut-off relay (no color): front of coil rear mounting bracket.
Sidestand (kickstand) relay (blue): left side, behind rear frame cross tube.
Headlight relay (yellow): behind ignition coils, behind flasher canceller.
Diode block: inside the headlight housing.
Neutral switch: located inside the engine shifter case side cover.

If you need more info on which connector goes to what I am sure we can help you out.

How about starting a build thread under Modifications? I would love to see some pics especially of the frame you are using. It doesn't look stock from the pic you have posted.

 

Post the rest of the project, the frame looks nice for whats showing.