1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

question about clubman bars

Discussion in 'XJ Modifications' started by acesfullof8s, Apr 22, 2011.

  1. acesfullof8s

    acesfullof8s New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    [​IMG]I have a 82 seca 750. My question is, will these clubman bars fit, are they wide enough? I have found a website that customizes them and makes them just a little wider. the width between bars is 9.75 the ones i found that are custom are 11 inches between bars. Thanks
     
    acesfullof8s, Apr 22, 2011
    #1
  2. GearN00B

    GearN00B Member

    Messages:
    36
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    WA, USA
    I would love to get those on my 82 750 maxim. My buddy has a pair on his 400, looks very badass.
     
    GearN00B, Apr 22, 2011
    #2
  3. acesfullof8s

    acesfullof8s New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    I went ahead and ordered them. I'll let you know if they fit well.
     
    acesfullof8s, Apr 22, 2011
    #3
  4. Militant_Buddhist

    Militant_Buddhist Member

    Messages:
    566
    Likes Received:
    1
    Trophy Points:
    18
    Location:
    Redmond, WA
    yes they fit. The gap is leaves 1/2" to 1/4" on either side of the atari.
    you'll have to do something about your brake cable (ie replace OEM with aftermarket mastercylinder)
     
    Militant_Buddhist, Apr 22, 2011
    #4
  5. acesfullof8s

    acesfullof8s New Member

    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    1
    Thanks for the answer. I have already upgraded my gauges to the ones from mikesxs, hated the atari. I was mainly concerned with the bars coming in contact with the tank while turning fully. Thanks again
     
    acesfullof8s, Apr 23, 2011
    #5
  6. Militant_Buddhist

    Militant_Buddhist Member

    Messages:
    566
    Likes Received:
    1
    Trophy Points:
    18
    Location:
    Redmond, WA
    oh, on that account I don't recall. Seriously though, take another look at your brake to master cylinder cable. it's too short to reach longer bars and so long that with a shorter setup (the clubbies) it kinks but not long enough to loop it.

    I just got back from the store with drag (ish) bars, a MAXIM throttle/switch assembly, an R6 MC, and stainless brake lines. Just sayin.
     
    Militant_Buddhist, Apr 23, 2011
    #6

Share This Page