1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

1981 xj650 maxim seat problem

Discussion in 'XJ Technical Chat' started by gomerkyle, May 31, 2011.

  1. gomerkyle

    gomerkyle New Member

    Messages:
    26
    Likes Received:
    0
    Trophy Points:
    1
    I've been trying to remove the seat to my 1981 xj650 midnight maxim. According to the Haynes manual I should be putting my ignition key into the helmet lock, turning it 90* counterclock wise, and pulling the lever backwards. Problem is, the key won't turn to the left. It will release the helmet lock though. What am I doing wrong guys?
     
    gomerkyle, May 31, 2011
    #1
  2. iwingameover

    iwingameover Active Member

    Messages:
    2,145
    Likes Received:
    4
    Trophy Points:
    38
    Location:
    Maryland
    Maybe you don't have an original lock, or it's messed up. There should be a peg that comes out from the and into the lever.

    I was always able to push the lever in toward the bike then rearward and it would come off the lock.
     
    iwingameover, May 31, 2011
    #2
  3. shooter05

    shooter05 New Member

    Messages:
    12
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Newark,Ohio USA
    as you turn the lock try pushing down on the seat at the rear. It may just be stuck.
     
    shooter05, May 31, 2011
    #3
  4. mwhite74

    mwhite74 Member

    Messages:
    967
    Likes Received:
    18
    Trophy Points:
    18
    Location:
    St John's Newfoundland, Canada
    Yah,

    The little lever that holds the seat in place needs to be pushed forward to allow the lock to withdraw through the hole, does that make sense? it's really tough to turn without doing that.
     
    mwhite74, May 31, 2011
    #4

Share This Page