Wiring Picture Needed - 82 650 Maxim

Mounted my engine back in my frame last night but I do not have a picture of the proper route for the cabling that comes from the pickups, neutral switch, and oil level switch. I'm good along the bottom of the motor where the two clips are but I cannot tell if it routes about or below the rear engine bolt. If someone has or can snap a pic in this area it would be much appreciated. Thanks!

 

Here's how I routed, can anyone confirm? I didn't get pics of this area when taking apart.

 

hope this helps

 

nice wiring diagram

 

Can't see the pictures.

Gary H.

 

Try know. I've been sucky at adding pics lately.

Thanks, but looking for cable routing through the frame.

 

Jay,
I didn't take a pic of mine either (i thought i did) but the manual says the clips s/b on the oil sump but there are two recessed indents on the bottom of the shifter cover that these clips fit perfectly into. I then routed the harness through a frame zip tie (that i didn't remove during the rebuild) located in front of the swing arm bearing cover and followed it up to the main harness connections and tucked it behind the side cover.




Hope this helps.

Gary H.

 

Thanks Gary for the pics, appreciate it! I did put the harness on the oil pan as it was originally. I think I'll just figure out the best route once I get more of the bike back together.