i'll sell ya real conversion kit, cheap !
i have two racks, i cleaned for myself, new seals, bench sync'ed, sprayed down with lps and put in a box
NO JETS in them, the needle valve is for...
I would imagine Android is the same
have to be careful how much you polish, that chrome isn't very thick and you can polish it right off.
if you heat a steel bolt and put oil on it,...
a pin from the star wheel part of the shifter ratchet???
same reason some people don't get vaccinated
zero free play gives more travel to the clutch arm.
can you stop it with the brake? my clutch is adjusted and maybe i could stop it with my hand...
air fin oil is right over there by the turn signal fluid.
maybe that's another use for WD40?
it's been a long time since i measured it, off on choke, flicker at hot idle, off by about 2K. could set it with a 10K pot and see what he likes....
i'll take a guess that your sync is off, #3 pipe is colder and #3 is the base for your sync
i did saranac lake ny to pittsburhg in my younger days on a bmw, 550 miles. i thought i did permanent damage to my ass
there's some dirt bikes that have a "hot start" lever, to start a hot engine it's like a backwards choke, leans the mix.
how's your air filter look?
about 2.2K resistor to + or take the bulb out
or get a kit from chacal
foot clutch and suicide shifter, just forget that stuff. that's for the all show no go boys.
at least get some kind of fenders unless you want a...
here's a oil change question.
does anyone ever change the oil in their briggs & stratton type lawn mower?
i can honestly say i never changed the...
you can hold on that for awhile, the best way to check the clutch is to ride it
mobil delvac 1300 works good in these, diesel oil. but your oil is ok
cam chains can make noise, easy to adjust
3 feet of old garden hose, one end...
well after a ride and you park it the gas and gas vapor is right over the hot engine.
if the vent in the gas cap isn't working right maybe the gas...
i have a theory, you do the test.
next time you park it, open the gas cap
i would think if you were to put two drops of gas in a new bottle of oil and shake it, it would smell like gas
don't know about that one
the petcock stops the fuel when the bike is off, read that again.
when the petcock stops the fuel, there isn't enough fuel left in the line to see...
if you were to push the high side till it touches and the piston was now straight, would the whole thing fit back on ?
maybe you don't need that...
take the seal out and it should just fall right in,flat, yes, no, maybe ?
if all else fails
open the gas cap and see if it helps
i've seen posts about the cam dots not lining up right but jumping one tooth on the chain made it just as far off the other way, only one is right...
take it out and see why it can't go flat, the bottom of the bore should be flat. could the bleeder be in the way?
if it all looks good lube it up...
347 posts in about 33 days is about 10.5 posts a day
we were truly blessed
if you can ride it home, do that. worry about it later
from second, down works better for me
[IMG] real basic from a dirt bike, extra leds for turns and high beam
so confused, Pevington Farm, Egerton Rd, Pluckley. Kent. TN27 0PF.... is "in the states" ?
new plugs are cheap and easy, might be all it needs.
does that pdf picture have white lines in it?
if your allergic to electricity test it with a ohm meter or continuity tester without the bike running
these have floating grounds, the mounting...
maybe, just maybe they were trying to get rid of you for a few days...?
i have nothing against loud pipes, but at 5:45am i might have...
here ya go
these might be old news by now
inspect those intake boots close and only take them off if you really feel the need to
there's 8 bolts on them, if one snaps, your in a bucket of...
check your air filter first.
a750 takes a Y-10 , a 650 a Y-11, i don't know where a Y-15 came from but maybe put the Y-11 in and see what it does...
the only way that can happen is if the petcock isn't doing it's job
if you take the valve seat out, your back to float levels again
i wrapped my lawn mower handle with it and it didn't last too long. at work we wrapped cable connections on cell towers with it, good stuff. but...
this https://www.3m.com/3M/en_US/p/d/b00011950/ get it at a electrical supply store or amazon
what color is the napa stuff
it cuts real easy though
any place that has officially branded underwear is not the place to buy a motorcycle https://bit.ly/3iu7byX
but now if they threw in a few of...
when you get to the sealant part, put some in the corner of a baggie and snip 1/16 inch off the corner
then you get a nice thin bead and you can...
get off the highway and stalls at red light, is a classic valve adjustment problem
you should pull off the fuel line and see just how long it will idle on what's in the bowls.....quite a while
i think you have other problems
those jets might be your whole problem, with some long screwdrivers you should be able to fix it without pulling the rack
those are really clean...
it might but the main thing is it causes the bike to not run
is there a reason you ask?
don't over think this just fix it