I just found a new tool had an old carb was just cleaning up and had it under hot water and had this old ultrasonic toothbrush. Thought I see ill...
if you can find it get some 3 in 1 oil warm it up or as hot as you can get it nice clean soda can works grate and pure in plug hole . I know a few...
Found a NOS air filter for my 85 xj700n been looking for about two years didnt want to pay 60 to 100 buck for one . So waited check ebay ever few...
Thank you glad to know before I order them
What about the one coil primary is 3.7 ohm should I replace it?
yes outside T134 inside T133
for got its a xj700n
My cap read #1 is 8.75 #2 is 7.65 #3 is 6.67 and #4 is 7.63 is this with in spec. for got it a xj700n 1985
ok because when checked with caps remover and from small coil wires primary I got 0 ohms from any on my plug wires .didnt do it from plug wire to...
Ok got a question on any xj coil how do you check the secondary resistance. It seem every where I look say one of two ways for the primary wires...
OK here is what I found so far battery voltage read 12.74 cranking read 11.3 votes. test on coils #1 and #4 Primary showed 2.7 ohms . secondary...
I stsrt my bike about ever month just to keep every thing oiled was getting ready to rebuild carbs .But today it wouldnt start pulled #1 plug...
for the time spent could have bought one got mine off Ebay used once paid 30 for it .I know there is a lot of fun making your own there a lot of...
nope oil clean it only happens when you take all the slack out of the cable and then pull it the cluck releases shit in to first find soft no...
that carb with the bad diaphragm leans out at higher rpm like 3000 + starts cutting out .
went in about 12 years ago said my iron was off the scale so was my zinc and chromium
I welded it for 30 years every day building gates from galvanized pipe my boss said its not dangers to weld now have stage 4 lung cancer its from...
If I use a trojan condom cut a piece of and use it on my bike going to start howl going down the road ? Or get all horny at the next bike that...
I know it kind of normal for an XJ to do this clunk in N to first .But if I adjust all slack from the cable and pull in handle you get a bad...
this is a air cold xj 700n maxim with Hitachi HSC33
Was just trying to save a few on a fixed income. 1 had a hole in it fixed it last year but noticed engine not running right pulled carbs off and...
Got a question I have seen on Amazon ,Ebay and a few other sites .Like this labwork Pack of 4 Carburetor Vacuum Membrane Diaphragm and...
I wrote the part number down some where for the seals from a dealer just cant get them. they even looked a carb rebuild kit. docent come with...
I checked with three dealers to see if they could get seals .They did try found the part number for them 2 even called the main Yamaha distributor...
I see a lot of the CB750 coils new for around 50+ a pair are these good for a xj700 maxim
has any one used diaphragms from JBM Industries and if so how do they do. Have a xj 700 maxim 1985 know one had a small hole fixed it but was...
thanks
got them in the mail had to buy a 100 of each but only $11.00 for all so very happy.Looking thru post dont guess it makes a big difference what...
Thank you
Thank you found them you dont have the # for the x rings do you .I think the reason I couldn't find them I was looking up # 11 o rings and it...
Keep trying to find #11 O rings when I do a search they do not come up as #11 . trying to find the size for them.
I am thinking about pulling my carbs and rebuilding them very hard to start and takes for ever to warm up. Was looking at the seals cost a lot to...