Did you ended up fixing the problem? I have the same issue...
However I noticed, while the bike was idling on 3 cyl, that i could feel air being sucked in through where the throttle shaft seal sits (under the...
No it doesn't fire when revving or on choke. It's completely dead. Spark plug gets wet and it still sparks
I'll check that out. I've also noticed that when the bike runs on 3 cylinders at idle, I would get backfires from the #2 carb (the one not...
So I just took the carbs out of the bike to check if the needle valve leaked and it did not. I even added pressure and nothing leaked. I also...
God dam I hope that's not it ahahah. It was on the side stand the whole time. I'll try next time.oj the side stand
I just swapped the #1 lead with the #4, and nothing changed. Also changed the spark plug and still same issue. So know it's clearly a carb...
Yes I did the church of clean, I event sent my bike to a mechanic to sync them. The first night I got the bike all cylinders where working, all...
Hi y'all I finally got my XJ to start! It's a bit cold here so it needed some extra juice from the battery to crank it up good. However I've got...
Hey guys! So I just cleaned up the carbs from my xj750 (pine-sol, compressed air everywhere, the whole thing) and its acting up on me. This is the...
Yes I removed and cleaned the emultion tube, saw air going through every hole and I passed a guitar string through every hole. I placed my hand...
So when I got the bike, it was running but poorly, started perfectly but had vacuums leaks. So I decided to take the carbs out end clean them up....
So I shot some starter fluid in the carbs while cranking and it fired up, so its not the engines fault. I went and did a wet set and saw that the...
And the fuel isn't pouring out or anything @k-moe , I think its just gas that's unburned that didn't go in the cylinder of the engine.
So I just mesured the amount of fuel in each bowl and its the same for all four of them ( ~60 ml). all my floats are set to 17 mm +- 0.5 mm.
- Not on center stand - I bench synced the carbs - Mixture screws to 2-1/2 - Its coming out from the ''mouth'' of the carb 1 and 2 (so the most...
1983 Maxim XJ750 Hey guys! So after I cleaned up the carbs, I installed the carbs back on the engine to see if I would get any good results....
Thanks guys! I had a set of spare carbs and the float set screens where brand new, so I'll used them instead!
Hey guys! I have a 1983 XJ750 Maxim and I just cleaned up my carbs and while removing the tank I noticed I didn't have an inline fuel filter on...