1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

? about my posible 1980 XJ650 bobber project

Discussion in 'XJ Modifications' started by streetmaster, Nov 29, 2009.

  1. streetmaster

    streetmaster Member

    Messages:
    228
    Likes Received:
    0
    Trophy Points:
    16
    I've been thinkin real hard about bobbin out my XJ650, but had a thought about the drive shaft. It seems as though most projects are limited to the length of the drive shaft.

    I noticed that the drive shaft universal has a flange at the end of it, and it bolts to the flange thats on the back of the motor, popping out of the trans.

    Is it possible to place a spacer between the two flanges of the drive shaft, and the motor, with out a ballance issue?

    It would be nice to gain atleast an inch or two between the tank and tire.
     
    streetmaster, Nov 29, 2009
    #1
  2. 3784rider

    3784rider New Member

    Messages:
    19
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    New Zealand
    chop it up,i like mine now than what it was before.plus it lowers the seat,an extend the swing arm to.
     
    3784rider, Nov 29, 2009
    #2

Share This Page