1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Connectors

Discussion in 'XJ Technical Chat' started by OpaJim, Jun 6, 2007.

  1. OpaJim

    OpaJim New Member

    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Mena, AR
    I need to reconfigure the Run/Stop and the Start wires in the
    female connector. Does anyone know if the metal sockets can
    be pushed out and put back without destroying the plastic housing?
    It is probably easier just to cut the wires leaving a stub and solder
    them in the new location, but why do it the easy way? 8O
    Thanks,
    Jim
    XJ650LH
     
    OpaJim, Jun 6, 2007
    #1
  2. BlueMaxim

    BlueMaxim Active Member

    Messages:
    1,986
    Likes Received:
    4
    Trophy Points:
    38
    Location:
    Central Mississippi
    They can be removed but you can also get the connectors from z1enterprises.com. They also have a tool for removing the pins but it can be done with a set of jewelers screwdrivers. It depends on the type of pin but most have a clip on the back that needs to be pushed down flat against the pin and then can be removed. Others have the clips on the side of the pins.
     
    BlueMaxim, Jun 6, 2007
    #2
  3. MiCarl

    MiCarl Active Member

    Messages:
    4,373
    Likes Received:
    23
    Trophy Points:
    38
    Location:
    Livonia, MI (Metro Detroit)
    One of THESE should do the trick.
     
    MiCarl, Jun 6, 2007
    #3

Share This Page