1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Kill Switch

Discussion in 'Hangout Lounge' started by DeadheadXJ550R, May 9, 2011.

  1. DeadheadXJ550R

    DeadheadXJ550R New Member

    Messages:
    22
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Columbia, PA
    Yeah, I've been "out to lunch" for a while as far as posting goes, but at least I have a good excuse....been rebuilding my Seca 550! I'm almost done, but there's one small glitch that I have to conquer before I take it out for a shakedown run. My kill switch and starter button assembly are on their way out, and I might have a source for a replacement. Only thing is, the assembly is for a 650 Maxim. Are these two parts interchangeable? I'm hoping that it will work with minor mods...at the least. Apparently, 550 Seca Engine Off and Starter Button assemblies are rarer than hen's teeth.
     
    DeadheadXJ550R, May 9, 2011
    #1
  2. tskaz

    tskaz Active Member

    Messages:
    1,878
    Likes Received:
    17
    Trophy Points:
    38
    Location:
    Saint Louis, Michigan
    Any engine stop/horn button assembly will work as long as it is for 7/8" bars (assuming you have the stock bars) with little to no modification
     
    tskaz, May 9, 2011
    #2

Share This Page