1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Master Cylinder Reservoir Cover Gasket Tear

Discussion in 'XJ Technical Chat' started by domroc, Jul 1, 2007.

  1. domroc

    domroc New Member

    Messages:
    15
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Connecticut
    I have my master cylinder off the bike and the rebuild kit is on its way from OBB, but I noticed a tear in the rubber gasket that goes under the cover on the reservoir. It's basically a hole in the corner. Looks like the PO may have seated it incorrectly and caused a hole to wear in there.

    Anyway, I know this part does not come with the rebuild kit, so I have a few questions:

    1. Could I repair the rubber and it still be safe to use? If so, what should I use for the repair?

    2. Is this part available to purchase on it's own?

    OR

    3. Am I stuck having to buy a whole new master cylinder?
     
    domroc, Jul 1, 2007
    #1
  2. RickCoMatic

    RickCoMatic Well-Known Member

    Messages:
    13,843
    Likes Received:
    65
    Trophy Points:
    48
    Location:
    Massachusetts, Billerica
    Home Depot.

    Liquid Electrical Tape.

    Before you use this product to facilitate your repair:

    The rubber Expansion Gasket has got to be Clean and Dry.

    Don't use the big brush attached to the inside of the cap.
    Let some drip-off that applicator into a tuna can or paper cup.
    Use an ARTIST Brush and apply successive thin layers until you get the results you need.

    Get another one from a boneyard as soon as you can.
     
    RickCoMatic, Jul 1, 2007
    #2

Share This Page