1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

New Rear Brake Pads Moan WHY???

Discussion in 'XJ Technical Chat' started by wonderdawg, Aug 5, 2010.

  1. wonderdawg

    wonderdawg Member

    Messages:
    60
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    So. California
    :?: :?:

    I just had my rear tire replaced and while I was at I had my rear brake pads replaced as well. Both the tire and the brake pads were definately in need of replacement. Now, when I apply the rear brakes I am getting a distinct moan from the rear end. I have tried the using just the front brakes to make certain that it was the rear and I heard nothing unusual. So any ideas?

    Regards,

    W. D.
     
  2. marshallnoise

    marshallnoise Member

    Messages:
    221
    Likes Received:
    0
    Trophy Points:
    16
    Improper seating of pad to rotor? This happens in cars too.
     
  3. RickCoMatic

    RickCoMatic Well-Known Member

    Messages:
    13,843
    Likes Received:
    66
    Trophy Points:
    48
    Location:
    Massachusetts, Billerica
    It might be a few things:

    Usually, it's because whoever installed then tookk them right out of the box and put them on-the-Bike without ... CHAMFERING ... the Sharp, right-angles from the EDGES of the Pads.

    Look-up: Chamfer Brake Pads ... on the Web.

    There is a Rust Ridge on the Brake Drum that should have been DRESSED-Away.
    If the New Pads catch the Rust Ridge ... They make an Unholy racket.

    Solution:
    Remove Brake Pads. Chamfer edges.
    (Round-off all the sharp, right angles with a Dremel, Grinder or a File)

    DREMEL Tool Sand-away the RUST Ridge,
    Keep the Tool MOVING around the Drum
    Knock-down the Rust Ridge and be done.
    Don't take any more material than absolutely necessary.

    (( I doubt you could take enough to upset the BALANCE ... But, keep it to a Minimum ))

    De-Glaze those New Shoes while their off.
    Hit them with 320 and scuff them up a bit.
     
  4. wonderdawg

    wonderdawg Member

    Messages:
    60
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    So. California
    Will it harm the brake system to do nothing???
     
  5. RickCoMatic

    RickCoMatic Well-Known Member

    Messages:
    13,843
    Likes Received:
    66
    Trophy Points:
    48
    Location:
    Massachusetts, Billerica
    Wait ... is this on a 900?

    Forget me thinking it was a Maxim.

    Chamfer the Brake Pads.
    All leading edges.
     

Share This Page