Is there a way to tell if my tool is doing its job correctly?
does it require a washer to seal one end of the port? this is the diagram I went by http://www.xs11.com/xs11-info/tech-tips ... -tool.html
Did toy find a design for that one or just come up with it yourself?
Im running 130 on my 750 maxim. Had to grind a weld a little smoother cause it was rubbing the raised letters but all is good now.
I used the build sheet I found here in the forums.
Maybe a little over $10 and fifteen minutes of work. LOT Of research and parts serching though lol. Not too bad
Hope it works. . gonna get to try it out this morning. . not sure about the fuel line used for the seals. its 3/8 OD and 1/8 ID. . was TOO small...