Yeah been through the pictures a million times, you can see where the seal goes on the crank case picture but no reference to the rod of shaft...
I am leaking a bit of oil from a seal near the front sprocket but the seal doesn't show up on the dealer pictures. When I remove the left side...
Does anyone know the dimensions of the fork seals for my '84 XS400 Maxim? The stealer wants near $22 each but I can find them much cheaper online...
On my XS400 I replaced the throttle shaft seals and checked every seam and seal for an air leak with propane and carb cleaner only to findI still...
Anyone know an aftermarket place that sells the airbox carb boots for a '84 XS400? I don't think they are available from Yamaha anymore. Maybe...
When mine leaked from between the carb on the gas lines my o-rings were still good but the aluminum oxidizing inside the pipe never made for a...
I use these for removing old gasket material of aluminun engine parts, they are made to not remove aluminum or gouge it. 3M bristle dics...
Ok re-did the cold and hot test with the new tester, my numbers are better. left cold 141psi hot 149psi right cold 143pi hot 152psi I...
But if a valve was stuck open squirting oil in would not seal this and make compression go up, so when my numbers went up doesn't that rule out...
These are my numbers for valve clearance, left exhst 0.007 left intk 0.006 right exhst 0.006 right intk 0.004 So my valves are in...
Well after fixing a few things I beleive I have foundthe problem, left cylinder piston rings. I changed the butterfly seals which were missing...
I forgot to mention it's for a XS400 twin, the YICS ports are built in to the intake side of the head. As far as I know there is no tool...