Addendum, Once you get the tank heated, an aquarium air pump, with it's output tube placed inside the tank, and all the tank openings open,...
Chances are that you set the tank down, after pouring out the surplus, and it was in such a position that the surplus on the vertical walls ran...
Have you noticed the crown in the road, and how the lane you are in slopes to the right? :lol: :lol: CZ
Cute! The only question I have is why didn't you round off the new post to match the other one. :wink: Don't you just hate people who screw...
I answered the way I did as a method to prompt you to use your powers of observation and analyze the situation. The shim sets in the bucket, and...
What is the shim setting on? What percentage of the thickness did you remove by grinding two or three thousandths off? Will that removal...
Thanks, that expains a lot. In this case, it sounds like I'm preaching to the choir. :oops: As you know, even going through the case would...
So far, all I've heard is " don't do it because nobody does it, and it shouldn't be done, and the factory says not to do it". Is there any...
Seems kind of counter intuitive, doesn't it? Laps are a standard tool in the machining trade. A lap can be a copper plate, and you know how soft...
"Faint heart ne'er won fair maid". Bunglejyme, if you have the facilities, and the know how, my opinion is that you will get a closer match on...
Yes, and do you know WHAT caused the "spit shim"? Correlation is not causation. Some one putting the shim wrong side up could be a cause. Or...
Well, yes I have. :D The exhaust nuts on an XS11 (XJ 11) have a hex (Allen) socket in them, and are rather short, and prone to abuse from PO's...
Does that include time and gas down to the dealer? :lol: CZ
And now, for the other side of the coin. Almost literally. I have an XJ and 3 XS 1100's and I and a couple of other members of that forum grind...
