Hi Folks, I don't like the wheels of my XJ900 on my project ( it's a '93) [IMG] I've made a cover for my rear wheel, but would like another...
I did this on my xj900 don't know if will fit on a 550, on my 900 you just have to make a tab on the seat side, it's a Kawasaki Z650 tank: [img]...
Hi Folks, I`ve got the pic in my folder, don`t remeber were I got it from, but it`s the look I`m looking for, any ideas ? thanks [IMG]
one of my needle valve set looks like that [img] I suppose it`s got to be replaced...
I think my carbs indeed needed a good cleaning ! [img] [img] [img] [img] <a href="http://www.casimages.com/i/140528025816424602.jpg"...
great I`ll check that ! (there was a kink in the fuel hose because I lifted the tank to have a better vieuw) Thanks for the Petcock tech and...
is the signal hose the that`s cut ?
it indeed doesn`t flow on "ON" nor "RES" the is on the ground now with the fuel hose just hanging there and no gas spilled... so what should I...
the PO apparently did cut the hose leaving it attached where it should on both sides...
[img] [img] [img] took my carbs out, gonna rebuilt them to the OEM specs first :-)
I`m going to take my carbs out today, I`ll take a picture of the back side, and no there`s no other port on my petcock, looks indeed like...
ok so here`s a couple of pics of my carbs and petcock [img] [img] [img] [img] [img] [img]
you make a good point !
