ALL rubber was out, yes. IT's back together now. How do I change the valve clearances?
I've done nothing. Where do you recommend starting?
If the bike has that much corrosion there, it's a pretty safe bet that there is other corrosion elsewhere. I would dump it, or use it as a spare...
this is how i did it. Cafe project The back part of the frame probably needs to be cut though, I did it and it was pretty easy. I did more of a...
Thanks! the carbs are now currently bathing in an acetone bath, with all rubber and plastic removed. I bought parts to make a manometer, I think...
nevermind. doing the carbs now.
The carbs may be the issue. I just checked and I don't think I'm getting gas to 3&4. However, I think it may actually be the petcock. So there are...
SO, now it cranks and fires but doesn't run, even with starter fluid. :?:
Thanks Rick, but my relays that could be switched are matched to their ports with the corresponding blue and yellow markings. I think I have a...
When I hooked the original Atari back up again temporarily, it said it was in neutral, is it possible for it to conflict with the relays?
I just took apart and cleaned the on/off switch after it stopped. It was cleaned with a brass wire brush on a dremel and wd-40'd etc, and the...
Well, it WAS running like a champ, fired up and ran the instant the starter button was pushed. I go the parts store to pick up some bullet splices...
No, you just need to test resistances.
And yes, I listen to classical when I work on the bike :lol:
