You think an XJ seat is bad you should try a modern sport bike for 600+ miles
I always pump them out with the master cylinder :)
Ok got it sorted out today! Two problems, first, after removing the mixture screws again I noticed the hole going before the throttle plate in...
pcguru, I"m going to disagree with you, I don't think there is much of a point in leaning these bikes over far enough to scrape the pegs, the...
Life was easier with my moped, only one carb to deal with :p
The carbs were bench sync'd they ought to be close enough for the engine to remain running I would have thought.
Holy crap this is driving me nuts! I cleaned it out very carefully (again), fluid seemed to be coming out in all the right places so the...
Body position, Get your body off the bike to stand the bike up more. You'll gain a lot of clearance, it wont cost you a cent, and it's safer....
Thank you! To the other posters, thanks but I've confirmed my float levels already and already checked for vacuum leaks (there were none), so...
Hello all, I'm fixing up my uncles '82 XJ750, all done and bolted everything back together and it runs super except it wont idle with the choke...
check the float levels in the carbs, check the turbo's shaft play, check engine compression. You're looking for flooding carbs, blow turbo, bad...
You'll need to measure the fork tube diameter (up by where the tripple clamps on). Different year R6 and R1's have different fork tube...
