I always wanted to try this, but just got an h4 converter running in the stock bucket. Wisamic 7" 80W Motorcycle LED Headlight Angle Eyes with...
I'll check the vent tomorrow though. Might be something simple like that I've overlooked
No way you're annoying man. I appreciate any help I can get. I cleaned all the little holes, and I didn't notice if any of the tops were ovaled...
K-moe I throw a block of wood under the front tire to level the bike when it's on its center stand. I need to get float bowl drain screw as #3 is...
Also fuel level in the bowls was 4mm, at least on the outside 2. I forgot to check until they were already on the bike.
Clutch feels tight, and low end performance is great. Doesn't seem to have this problem in lower gears, and compression check last year was good....
The old hand behind the muffler feels like there's equal back pressure
No. Only in higher gears
Slide diaphragms are in good condition, no tears or pinholes. The 205 jet is toward the motor, which I believe is correct. Throttle cable operates...
Haven't running synced the carbs yet, but don't figured that would affect it too much at full throttle. Air filter is stock, and clean. I bought a...
So I took the old girl on a ride YESTERDAY, 1982 Maxim 650, and she wouldn't get past 6500 rpm. Now it will do it in the first 4 gears as far as I...
Well my concern is that even the ones in tolerance are close to the limit, so I'd like to get them on the looser side, which means that all 8 will...
I checked all my valves cuz the bike had no top end power. Haven't really had a chance to give it a good lookin over, but it seemed to run well so...
