I've always enjoyed using my dremel and lately don't have much oportunity. Here's my big chance ! Better get some black epoxy first. Marty
It sure would be nice if the original setup had screw style on both ends of the leads. Marty
Great !! I reached down to check if my plug cap was indeed tight and got a little tingle. Figured I'd put some new wires and caps on from the...
Diaphragms are good and the pistons were clean. I buffed them a little with a cloth to get off any superficial stuff, but I didn't polish down the...
I'm thinking I may have a problem related to this topic. When I let off the throttle and pull in the clutch the engine still revs high and slowly...
Thanks for the heads up on the little screws. I for sure would not have thought of that. The Muppets are cool.......Wakawakawaka indeed !...
Where is a good place to get these seals if Yamaha does not list them ? Are they nothing more than O-rings ? If yes than Buna-N O-rings should...
Thanks I shall give 'er a try. And yes, the rubber on said bolts is a bit screwy. Marty
I put in my new gasket and it fits perfect but it tends to leak a little at those little half moon spots on the right hand side. I took it off and...
Don't forget to try .....carbkitscapital.com Marty
Danilo have I got good news for you ! carbkitscapital.com ...........Has the carb diaphragm thingies you're talking about. And to...
Carbkits.com ........has intake holders for $ 86/ set new. Thanks for the kit tips.
Right ! Valve cover gasket. I will take it out and clean it then try the permatex idea. Looks like it has some sort of sealant that squeezed out...
