Does the oil light flicker as you start the bike up? If it does then your oil light is probably OK. Mine does not come on with the ignition but...
You will probably find as I did on mine that there is a multi-block connector under the tank which does the power from the fuse to all of these...
XJ600 marked on the sidepanel kind of gives the model away.
The tyres width and profile are there to see. As I am sure you are aware, the second figure is the profile of the tyre expressed as a percentage...
And my first pic above has a large "T" marked on the flywheel.
Tighten each one no more than a quarter turn at a time then take the bike out. Do not over tighten any that don't want to move. I had this and...
It doesn't matter how many revolutions I turn the engine. It remains in this odd position. The crank is set here....
Right, found the dimple marks for the valve timing and it looks like my valve timing may have managed to get itself slightly advanced. The arrow...
I can't find the "notch" on the cam to line up with the arrow on the cam bearing. But seeing as my manual says this is only on the exhaust cam it...
Just how do you install a float upside down? I'm assuming this is what you did as the tab for adjusting the float height is attached to it. Or...
Most likely 5 or 6mm. This is usually the case for just about all Jap bikes chainguard bolts tat I have seen..
Where are you getting the specs to adjust your float heights? I had a similar problem when adjusting mine using the specs given in the HBOL....
Is there any way of checking for holes and defects other than holding them up to the light and having a good look? Also, is there any way to...
