I think you might be right bluebass. Another project has emerged however: think i am going to buy this off a guy in stockholm....
3d update! - Great sucess! And fail... Cleaned all the passages again and flow increased. You are right about sync being sligthly off so I...
2nd update Float levels have been checked and corrected so that they are 3mm below bowl gasket face (+-1mm) Intake boots have been planed and...
Update: Checked clearances and all are withing spec except #4 which is 0.21 out and 0.16 in. I am wondering if this is the main problem, I dont...
Ok. Thanks for the input. But like I wrote I have just tested the pilot passages and fuel/air flows freely through them... What are thoughts on...
Could you shed some light on the front end swap! Looks very nice and a great way to add better perfor ance to the bike i reckon!
Thanks for the advice. Have an good tips on how t seal them while still being able to take them off? Also what does my enrichment circuits (which...
I forgot to mention that it returns to idle significantly slower than before as well!
I pulled the carbs today and made sure that the pilot passages were good as gold! However; Cyl #3-4 are not responding much to colortuning but...
Hi all As the topic reads I have an issue with the bike hesitation below 2.5k rpm The carbs have been rebuilt Valve clearances in spec...
Thanks for the replys fellows. I did fix it with jb-weld last season and it had gotten all squishy over the winter so I did another fix with it....
Thanks for the tip rice burner. Seems like the jbweld is holding up semigood. Not really liking the gasoline immersion... Will try to file it...
