can i ask if the x fitted ok also did it run fine thanks
does anyone know the exact settings for float bowls
Hi all I have an XJ700 with after market pipes, K&N and stage 3 dyno. I have a bad misfire where it leaves the pilots on to slides around 5000rpm...
I started my hobby becouse I could not live on the money I was earning in the UK repairing motorcycles. I bought a couple of scooters for £50,...
Mate I do make a living out of it and a damn good one :o)
Hi Guys been away for a while opening my own shop, Based in Cardiff , Wales UK and am now looking for a NICE set of pipes for my XJ700N If...
Anyone know what the fuel level heights are on an XJ700N and also where to measure from please
I know in the UK they are about £5 so maybe this is why
If you get a drift, you can slide it down inside the sleeve between the bearings and with slight leverage get to the bearing inner edge. Try to do...
I knew it was lean, so I went back to square one. I stripped carbs and blew them through, Reset float hights, checked boots etc. I then went onto...
I now have it bang on, I have set the dyno kit to 116 main jets, set on groove 2 (from bottom) on needles and balanced the carbs out. I have...
It was the same before, I assumed replacing mains, needle etc would cure it, it is a stage 1 and 3 kit in one, the only differance being mains....
