Thank you for your support... When the bike is running on the center stand and I put it in gear it dies very quickly and the rear tires hops, but...
So i havent had much time to work on my beloved XJ lately due to training for my deployment to Afghanistan coming up next month but I am buckling...
Well thank you for the motivation... I am leaving to Afghanistan in the first week of march so hopefully I get it going before then so I dont have...
Well after putting the bike on the centyer stand and watching the rear tire, it does in fact jump when putting it into gear before dying, also...
I took no offense from the previous post IWIN, in fact I could use the humor or else I would be punching and breaking everything in sight. The...
HAHA thanks thats a great start... So i started tracing some wires... and while the bike was off I rocked the turn signal switch from side to...
No jump at all it just dies... But the I try to start it in gear with the clutch fully engaged it does pull forward a little. As for that shop...
This problem didnt always occur this way, It started after taking it to a shop to re do the whole wiring harness, SIMPLIFIED which has turned out...
I feel their pain. Im not one to give up but damn this thing is giving me a run (or lack there of) for my money. I did try to bump start it into...
So I did the clear tube method and they are all spot on. The bike is running on all four again. But still when I put it in gear it dies...? What...
Correct me if im wrong, but arent you not supposed to run resistor plugs on these bikes unless the coils have some kind of resistor? Which would...
Unfortunately I didnt know about wet setting or dry setting this is my first rebuild. So I just slammed them back in. I did the clear tube method...
Yes I am running a brand new inline filter. and I made sure that there was no debris in between the fuel rails with high pressure air. I will...
I did repalce the float needles and seats