Need help. I'm rebuilding the master cylinder, but ALL the aftermarket rebuild kits available online are WRONG! The diagram in the Haynes manual...
Re: Mystery Master Cylinder 7A7 On closer examination, I found the number 7A7 stamped into the cylinder. The number is located just to the left...
Can't seem to get this picture attached. http://photobucket.com/luminaman
Here's the link to the pic of my master cylinder. I ordered a rebuild kit, but the piston was too long. Ironically, it matched the one I removed....
It's an 82 Maxim XJ 750. I cannot seem to attach a photo. I will gladly send to your personal email if you're willing.
I have an 82 XJ 750. Unfortunately, I don't think the master cylinder on it is for this bike. The markings on the unit are 5/8 6 V I (or 1). Does...
When you say to only open the bleeder screw a little: do I pump up the pressure in the master cylinder, hold the handle "in", and then open & close?
I'm about to throw in the towel. All I want is a front brake system that works. So, I removed the calipers, cleaned the pistons, installed new...
HELP! I've installed the new piston, gasket and rubber cap. The piston moves freely, but no brake fluid comes out the hose end. Have I installed...
I'm trying to remove the spring clip that secures the master cylinder piston in my 82 XJ 750. Dumb question: am I trying to contract the clip or...
I just replaced the piston seals and brake pads on my 82 Maxim XJ 750. I have repeatedly bled the lines, and no air bubbles appear. When I do a...
