Sold
I'm moving and haven't used these tools in a long time. Gunson Colortune plugs 12mm and 14mm. Also have the tool to hold damper rod in the fork...
@Roads Scholar I would be careful removing or gutting the fuel check valve. The purpose of this valve is to not let the residual fuel in the...
Even the original YICS tool rubber will start to melt if left in too long. You remove it in between runs to let it cool off a little between...
I bought a "cheap" ultrasonic cleaner, and it didn't do anything for me. Don't know about expensive ones. But I cleaned many sets of carbs...
Look closer at Simmy's last post. If you're running 15psi of boost with the original fuel pump, it explains your starvation, or at least it could....
If you want to know if it'll run, do a compression test. If the numbers are off, check the valves, adjust, then do another. That'll tell you if...
You don’t have to go “new” just a little more modern. And sure 200HP on a motorcycle gets a little silly, but 120 HP isn’t all that bad. Throw in...
This is normal with aftermarket springs. The spacer sticking up from the top cap just makes it a little trickier to thread properly, but reducing...
24V charging could ruin the battery. So you may have to replace it once the charging system is sorted. Depending on what voltage is getting to the...