8O
The corrosion issue is not severe. But overtime corrosion of the carb bodies will take place which can result in the fasteners galling into the...
Thanks for the note 8) The fastener sizes are listed there next to the part numbers if you would like to go another route. I did not use...
I am going to catch flak for this I think but I wanted to say. I have had many troubles with yamalube over the years, namely yamalube 2R but I...
ah ok, I knew there was no way those factory screws are stainless.
But are plated. and are you sure they are stainless? quite certain they are yellow cad plated steel. if only i could find some cadmium...
here you go guys, https://www.fastenal.com/content/feds/p ... rosion.pdf I have extras now too, these are sold in packs not by the screw,...
Stainless steel fasteners and aluminum don't get along, this is according to the galvanic index. Also this is only like 10 bucks plus shipping...
I didnt find anything similar when I searched and I think this might help some people. I have been working on a rack of carbs (hitachi HSC32) and...
Glad to hear you got her sorted out.
The bowls are clean but did you clean the tiny little opening in the side of the bowl that the small brass tube goes into? It's a tiny little...
don't get me wrong I'm all for it. I raced motocross growing up which I think gave me a real respect for the "extreme" sports if you will. There...
I'm in the same boat as this guy, '82 xj650j. Grey is defintely 2 and 3 just wen't out to the shop and checked.
I've been to the Isle of Man, Beautiful place. Yes they are a bit wacky, I talked to a few people about it when I was there, brass clangers...
