Seat Pan is done. finished it off Tonight . I'm quite happy with the results [img] [img] [img]
I think its an 1 1/2 inch flex coupler (rubber) just ask the sales guys they should know.
Gas tank sealer ? Is the inside of the tank clean ?
Well got a little more work done this weekend. I got the round bar welded to the edge of the seat pan [img] [img] Fabricated some z...
Make a T out of the same tube that you will use for your hardtail section. Fish mouth it weld it. Stick the upright part of the t section in a...
The NHRA also specifys 1 5/8 o.d.x .118 mild steel tubing, or 1 5/8 x .083 chrome moly tubing for roll cage tubing. Frame tubes on the xj rear...
The big difference between gas, mig and tig welding is the HAZ (heat affected zone) . Gas welding has a large HAZ, mig is smaller, and tig is...
I cut the backend of the bike off, the air box slipped right out ;-)
The "PLAN" is to weld 1/4 inch round bar around the edge (very neatly) then make a seat pad contured to my...seat cover it with leather then rivet...
I hear ya. nice job though. It's looking spectacular. Better than some jokers on TLC with unlimited funds could do!
Don't sell the mufflers till you ride around for a couple of hours with them off...:-)
The metal for the seat pan was 1/16th inch plate, but I am going to wrap the edge in 1/4 inch round bar to make a nice finished edge. 16th is to...
Hey Plumber love the seat you steal all my good Ideas before I have em...
Got some more work done this weekend. Rear frame welded seat pan built and mounted carbs cleaned pics below. [img] new sections welded to...
