i may be interested in the driveline, ujoint yoke, wiring harness and everything it plugs into (engine only)
I will probably use a small car MC (i have a few aircooled VW's around here in various stages of restoration) with a proportioning valve.. Hoping...
according to a post on http://www.xjbikes.com/Forums/viewtopic ... brake.html , I should be able to bolt an xj900 rear swingarm up? Can i get a...
Without starting anything here, im fully aware of the characteristics of a bike without a front brake.. Im working from the rear forward due to...
Ya- i will be gusseting the crap out of the entire frame once im happy with the suspension d&d - right now, its basically tacked together really...
Good info BluesBass.. Sometimes its difficult to know whats really going on in a forum, and i haven't been here before this build, so im happy for...
I was looking at that exhaust stud repair - i caught myself wondering if you shouldn't hit that steel insert you made with a punch in a few places...
Or you could mount the base of the fender to the swingarm and run struts from the rear of the swingarm to the back edge of the fender.. that way...
The driveline on http://www.xjbikes.com/Forums/viewtopic ... rt=30.html is exactly what i had planned for the rear driveline - the intermediate...
I get that.. This is a long term project for me, as time is a bit limited.. I dont know the scene in this board, and thought it might be too...
Spline cutting will probably be the main issue with a custom driveline.. the splined area is typically hardened (treated) steel. I dont see any...
Sorry for taking so long, but i moved - and got a shop again :) built a bike lift with a friend, and now im finally back to work.. Here is...
ahh.. driveshaft :) here is our plan: carrier bearing in end of swingarm (where ujoint used to be) - extend driveline a few inches to clear...
ok.. so I have been trying to get some pictures rounded up on my build.. Obviously, I haven't completed it yet, but its getting there piece...
