Len Chacal is the man to talk to. Click on the link at the top right hand of the page (the engine) or find his catalog in the forums or just...
i ride daily in the winter...unless there's snow or ice on the roads. but PA doesn't exactly qualify for the great white north. this past winter...
does anyone know for sure whether or not front crash bars from an 82 750 seca would fit an 82 650 maxim?
i just looked through some carb photos on this site and am not seeing any springs on the outsides of carbs 2,3.
i bought one from him about a month ago, haven't used it yet but hopefully this weekend i'll get to it. i'll say this, these days everywhere you...
rick, i loosened the cable and still have the idle problem. fitz, i tried realigning them with a glass plate based on some threads i found here...
removed the starter reluctantly yesterday and cleaned it thoroughly. it was pretty nasty. everything checked out spec wise so i reinstalled it...
nice read, congrats...and amen to your last sentence
where are you located?
yes, i replaced the shaft seals. but i just went out and started it up and pressed down on the sync screws and the idle dropped. i noticed the...
that's where i'm at right now, vacuum syncing with a morgan carbtune, and the yics port blocked with the tool. i've got them synced up really...
MN, i tried the propane test with no results, and i polished everything until clunk test was passed. the fuel level was set w/clear tube method...
can improperly adjusted pilot mix screws ALONE cause a hanging idle and revving? the reason i ask is because i've put the valves in spec,...
