Okay thanks for the tip!
What order? Like this? (Might be a silly question) Carb>>Nylon washer>>spring>>stainless>>screw
Update: We are rebuilding the carbs again because we found out we didn't replace everything that needed replaced last time such as throttle shaft...
Hm... well now I am questioning myself a bit. I might have to open her back up and check the air jets.
The broken drill bit isn't an issue anymore i got new bowls from a local motorcycle scrap yard and cleaned them up really well. To be honest they...
So my neighbor is a mechanic and came and took a look at the bike. After listening to it he said it sounds like either the valve clearance is off...
It does have gas and the petcock switch was set to PRI when we were doing this.
Will check tomorrow and report back.
So, I bought a vacuum sync, yics tool, and colortune. We were trying to vacuum sync it tonight, BUT we are having a lot of trouble getting it to...
OK, so we got it running tonight and it was still kind of fishy when we took it for a ride. Valves are in spec now & float levels wet set and...
Okay so 3 of the enrichment circuits are good, but one is a little messed up. We can't seem to get it clean, and I think we may have broke off a...
Thank you! Definitely makes sense with a picture.
Oh ok. So the mixture screw is the one on the outside of the carbs though right?
Checked the valves and they are way off, so ordering new shims. Then going to wet set float, we did dry set but I was a little confused about wet...
