Hi guys! here are resoults after measuring compression at 2 cyl. 117 psi! K-moe has right new rings has to seat. Bike starts immediately hot or...
I do not believe! Motorcycle fired after 4-5 seconds of cranking. Completely cold! before it was impossible. Now idles for about 30 minutes ....
i dont hone cylinder bores because there was still some of factory honing. compresion on cyl 3 goes up after puting manny times petroleum into...
Hi, so I've check cylinder bores and they are in spec, for safety replaced piston rings on cylinder 2. all pistons was cleaned and measured...
ok I finaly borrowed another compression meter, and the results were the same, but aprox 10 psi lower on each cyl so it could be because of meter....
ok forom beginning, I romoved every silgle ruber piece incl throttle shaft seals before dipping in carb cleaner i removed caps from idle...
First i dipped carbs in a carb cleanig solution based on toulen. then i spreyed carb cleaner under hi prosure in every passage and using wire...
Hello, my bike have problems with starting since i remember. its XJ550 1984, aprox 30 000 miles things ive check/replace: -full carbs clean...
Greenbike Ive try this after pourhasing the bike. Polock thank you i will convert to metric and try to find them in my local suplier. I will...
Polock so uou say that i can simply replace the seals with the orings? that would be great! is that safe and long term solution? and what do you...
Ok guys, i dissembled carbs again and clean them in ultrasonic cleaner this time ive break the rack, ive notice that throttle shaft seals are...
