hi bigfitz, once again thanks to you for the interesting info. I can confirm that we are dealing with a dummy after all. (Sounds like something...
Thanks guys, great food for thought. It was the idea of altering the stress points on the camshaft that was making me reticent. Sort of like the...
Tightening down the valve cover after fitting new shims, without a torque wrench. I overcooked it. The Bolt at Intake 3 snapped. So I can't get...
Hey guys, many thanks to you all for the excellent info and advice. What I found last night while checking the HT leads is that the cap just...
Hi Rick, Thanks for the reply, appreciated. I will adjust the mixture screw outwards as you suggest. Can you tell me though, just out of...
Hi, thanks for that. What did you use to do that with ? Do small adjustments make noticeable changes ?
Are you saying that blowing up my engine is just as likely with the valve clearances a tad on the loose side, as it would be with them being too...
I didn't replace throttle shaft seals since I don't have a vacuum leak with a high and hanging idle. I've sprayed all around the carbs and boots...
Haynes specifies 2.5 turns for my bike, the 900F, which uses the Mikuni BS36; and actually specifies 2 turns out for the 31A, which uses the...
Will do the pics thing, hopefully today if I can. I set the floats to about half a mil either side of the datum line. If any are on the low...
Thanks for replies. I forgot to say that I had already wet the coils and leads with sprayed water and run the bike in total darkness - no sign...
Are the links to these movies working for everyone ?
Regarding your brake light issue - the rear stop/tail lamp is two filaments I'd guess. It could be that the brake filament in the lamp is broken....
I hope it's ok for me to repost these movies as a new thread with a more accurate title. Beneath the videos are the details which I have...
