Can you effectively gauge the clunk if the carbs are fully assembled? Or do you need to pop the hat, remove the springe, and unseat the diaphragm?
If it's like my 700, the nipple on the top of the petcock is for suction and connects to the carb manifold on my number 2(I think that it shouldnt...
That is an immaculate bike! Sorry to hear that you're leaving Yamerica.
My battery is grounded to the engine on the riders right side, behind and below the air box. Also, I know it's not recommended but I was having...
Ok. So I attempted to sync my carbs today. I am following Ricks old school method with one vac. gauge. I first used strips of gym socks soaked in...
For some reason I was under the impression that the reason the yics tool had individual segments for blocking each port was to leave necessary...
I'm sure that this has already been addressed but...If the purpose of the yics tuning tool is to block the ports in the yics passage so that you...
Check this out for the manual. http://www.4shared.com/dir/1570443/a2eb ... aring.html I do not condone the reproduction of copyrighted...
oldskoo11, rent a compression gauge from an autozone. The rental fee is fully refundable. Then you can effectively troubleshoot this issue.
I replaced mine with the home depot couplings that are mentioned in a couple threads here. They are very pliable and fit perfectly snug. They...
If you've kept the drained oil you could measure the amount drained. If there's more than you put in, you can assume some gas made it through...
Yesssiree. It is indeed the tail light wire that has the issue. There are two areas along the wire that seem suspect but it's hard to tell what...
So...I went through and cleaned up some connections. I turned the key to see if the main would blow again and now something is starting to melt....
Great Idea. I'll give it a whirl.
