last year my my bike ran fine with no starting problems. This spring is different. AS I was trying to get her going my starter would make a...
Yeah I know what your sayin. Here in Grande Prairie it's -18 C, -15 F. There's snow on the ground and my ride is stuck in the garage.
Staring out my window, looking at the ice and snow here in Prairie. I can't ride now but at least I can get her ready.
This is starting to make sense. I was trying to tune #3 to #4 . No wonder I couldn't get it right. I'm going to bench the carbs again and try to...
YO! One more question. What is colourtune?
OK, So I did the bench synch on my carbs. Then I built the two bottle tool to synch my carbs. I connected my tubes to the vacume inlets. But I...
Help! I just don't get the idea of carb synchronization. I've read my shop manual I Cleaned out my carbs but i just can't get them to run...
Ihave not done a bench sync or a vacum sync. How do I do that? Right now the bike starts good and idels smooth. But she will not drop below 2500...
My mistake. I am talking about the idle mixture screws. I've already pulled out the carbs and cleaned them out. My idle mixture screws were all...
Hey tumbleweed! re you having a bad day or what? As far as 2 by 4's go the measurement is taken from rough cut lumber. Then it's run through a...
First of all, thanks for the great advice. My throttle cable was the problem. I've replaced the cable and she starts great. Now I can't seem to...
Thank for the help guys .Yes my cables were reversed. Fixed that. I noticed that my throttle cable is shot, so I've ordered a new one. I'll let...
