That is for sure pieces of the primary chain guide, I just pulled my motor and split the cases to replace mine and am in the process of putting it...
The timing it still on, but there appears to be slack in the chain. Maybe I have to remind the tensioner its automatic by doing the clockwise then...
Well I got the bike out for a ride today, on acceleration she smoked some, but I hope this is because the new rings haven't broken in yet fully,...
Heh, yeah I wish it had zippers. I've got the tear down and rebuild procedure down to a T now. Hope I don't have to do it again for a loooong time.
Just want to say thanks to everyone who gave suggestions on this one. After another complete tear down, a light re-hatch of the cylinders,...
If this all doesn't work out I started looking for another engine. I think I found one which the owner says is in good condition, its actually the...
Ok, I don't have the bores here, they are in my buddy's garage still on the bike, but I just spent the last 3 hours going over the head. I removed...
One of my first thoughts was that the oil passages that run by #4 might be leaking, I did take a good look at the head gasket and its squeaky...
Yeah, I checked the clearances, and the rings put in were the 1st oversize, the end gaps filed to spec. I have already removed the bores and the...
Oh yes, the bores were honed and the ridge broke. The rings appear to be seating in fine, the other cylinders have no problems and they all...
Well after doing a complete engine rebuild, replacing the rings, valve seals, all the gaskets and o-rings and getting the engine back together #4...
Well I just finished a major rebuild of the engine, over the winter I completely tore down the engine, replaced the valve seals, rings, all the...
