yeah that sounds like the speedo cable, have you tried tightening it? The bottom leak may be the o-ring from the oil level sensor, its right on...
or fail to take out the slack in your timing chain after alligning the cams...not that I would know anything about that!!
make sure you dont have the throttle and choke cables swapped
does the kit come with the MC reservoir cover gasket?
Thanks Rick, can you point me to a good how to on MC rebuild? While I'm at it I'll go ahead and replace the break line too.
The front brake on my 81 maxim 650 felt a little spongy and wasnt grabbing as it should so I decided to bleed the system out of the old fluid and...
Just wanted to take some time to thank everyone on this board for their invaluable help in bringing back to life an 81 maxim 650 my son and I...
Also, after you get the cams aligned with the crankshaft, make sure you get ALL the slack out of the chain. There are specific steps to follow for...
Re: Ouch, never heard of this before (cam sprocket shattered Alchai, did your valves hit your pistons? or just bent valves? I havent removed my...
I wished i had checkd the forum 5 minutes earlier, i just bought a pair on ebay...but thanks, i'll hit you up if those dont work out.
In my case, I'm pretty sure it was because i didnt torque the sprocket bolts. I just tightened them by hand. I had to remove the head to get some...
The exact same thing happened to me this morning, intake cam sprocket broke in 2. I was able to fish them out with a magnet but coulndt get to the...
I had the TDC mark on the crank aligned with the marks on the cams. I just couldnt remember which spark plug the #1 wire went to, far left or far...
