Hi there! I'm currently working on an XJ 650 4KO 1980. I've dismounted the engine and noticed that the plane bearings on the crankshaft are worn...
Hello people, I recently bought an unfinished Xj 650 project as a start for learning more about motorcycles and how they are working. Right now I...
Hi All, Does anyone have any experience with using parts from a 1982 XJ 650, and fitting them onto a 1981 XS 650 ? Neither bike is in the garage...
I am tearing down an untitled XJ650 have have parts to sell. Have been posting on eBay. Currently listing rear fender with light. Reply if you...
It started off Iost my turn signals neutral light, break light, and rpm tach would quit working if I hit the rear break or used the turn signal....
Hi all, I am the owner of an 83 Maxim 750 that I've modded quite a bit, so when I saw someone selling an 81 Maxim 650 with a bobbed frame I...
So I put this 1980 xj on the road yesterday after making one good bike out of two, And had about 38 miles of fun then wheeled in to home base. I...
Quick question. What "Length" should I have my forks out at. Currently, they're sitting so the front tire has about a hairline of clearance when...
Hey y’all. Zach here with an ‘82 650 Seca (non-yics). I’m looking to beef up the front end with a fork swap. From what I’ve seen, this is a...
Midnight Maxim. Mostly there. Got it for parts a few years ago. Out of curiosity, I cleaned the carbs and put in some gas. Fired up and throttle...
I recently purchased an '82 XJ 650. Neither of the turn signal lights worked and the headlight was dim. I don't know much about the electronics...
sup, guys Faced an issue. Saw that oil leacking out of it. There was a tiny crack when I examined it. I know it is not from metal, I think if it...
So, I had my tank serviced by a radiator shop a bit ago after I stripped it down and found some pinholes. They fixed them but told me the tank is...
Just wondering if the rear wheel is offset. I’m trying to align the wheels and they do t match up, even with the adjustment screw dimed in the...
so, the Haynes doesn’t seem to list these... looking if anyone knows the torque specs for the engine mount points and the swingarm to drive hub (4...
I have a major problem removing the oil seal on the lower fork boot of my XJ650. I got it apart and down to the retaining clip no problem, but per...
Just bought a 1982 XJ650 seca. It needs to be re-wired. Does anyone have a wiring diagram, or know where to find one?
XJ650 Clutch Replacement. New Friction Plates and Springs. [MEDIA]
okay so I recently just rebuilt the carburetor to my bike. I’d have to check what jet was placed where in my carb I’m pretty sure the bigger one...
So, this just happened today. The bike was running perfectly fine and today when i go to start it, it took forever to start, just cranked and...
its getting close to the time to put the bike away. I was just wondering though if it's worth doing a restore over the winter or just leave the...
1982 Maxim 650 - not getting fuel. (VIN 5N9 - 002151) Hey guys, first post here on the forums so thanks for having me! I recently acquired a 1982...
Hello Everyone! disclosure, I am new to motorcycles and this is my first ride. I have recently run into a problem with my Yamaha xj 650 1980...
Hello! Greetings from DK I have a question. I have just bought a xj 650 4k0 from 84 I'm wondering which parts are similar to other xj 650...
Hey everybody I have a 1982 XJ650, It starts right up but won't stay running. I have played around with the idle adjust screw and it will work for...
Hi everyone, I am a noob with motorcycles and this is my first ride. I almost have everything ready for a first ride besides an oil change.... I...
Hi Everyone ! I picked up my Maxim in the spring and have been working on its since I got back in the summer. I am having issues with the...
I'm looking for an exhaust collector since mine is so badly rusted, it can't even be considered scrap metal. As stated in the header I'm looking...
Hello Fellow Riders, I just picked up a 1981 Yamaha XJ650, the owner already did the Bobber conversion on it and it looks pretty good. Some...
[MEDIA]hey guys, this is my first bike and I just rode it from California to Seattle and I don't really have any handy friends here in Seattle who...
The bike was kept outside and was given to me by a friend. I have a clean title in hand. I got the bike running, but after a few rides- nothing....
so 3 years down the line i plan to finish what i started . so i took 3 weeks off work picked up an 82 750 maxim .[ATTACH] so this is the 650...
1981 Yamaha XJ600 Midnight Maxim - runs but needs some work. Horn and starter buttons broken. Needs new battery. Added straight bars but it comes...
Finally got it "done" still needs a couple little odds and ends but its running.
Got my bike for $900. Drove as is for the first year then decided to tear it down a make some mods. After I got it all back together rode for most...