1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Clean Title - 1980 XJ650 Maxim 1 - No issues

Discussion in 'For Sale, Trade/Swap, Wanted' started by Palmer650#2, Dec 23, 2022.

  1. Palmer650#2

    Palmer650#2 Member

    Messages:
    62
    Likes Received:
    20
    Trophy Points:
    8
    Location:
    Middletown, MD
    Take a ride on the smoothest and most satisfying vintage Yamaha… the XJ650 Maxim 1! This beautiful and bulletproof inline four cylinder engine and shaft drive make this a bike you can ride all day and not be uncomfortable from vibration.

    (Clean Title included!) Never been dropped. Asking $1,800.

    You can benefit from the insane amount of money I spent getting this 42 yr old badboy in road worthy order. I went through the carbs, brakes, valves, tires, fuel lines, gas tank, cables, battery… and the list goes on and on!!! There are some minor blemishes on the tank, seat, & side cover but the first scratch is always the most painful one so that’s out of the way. Starts instantly and runs smooth with low mileage under 10k - no issues!

    Cold Start-Up video on 12/23/22 in 17 degrees:

    I’ll even throw in a box of extra parts and a 1982 Xj650 complete parts bike!

    - New brake lines and master cylinder.

    - New clutch and throttle cables.

    - Like new BMW 1200 enduro tires.

    - Freshly cleaned and sealed gas tank.

    - New vacuum-actuated petcock, fuel filter, and fuel line.

    - New carb manifold

    - New plugs and battery

    - 4 into 1 exhaust headers

    - New brake pads

    - Motor protector crash bars

    - New clutch perch and lever

    - New Flat Tracker bars (A lot of the replacement parts are because I converted from the buckhorn handle bars and had to customize all of the controls because of the routing and cable/line lengths.)
     

    Attached Files:

Share This Page