1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

does anyone know the carb pilot screw settings

Discussion in 'XJ Technical Chat' started by BlackSpanker, Jul 17, 2011.

Page 2 of 2
  1. RickCoMatic

    RickCoMatic Well-Known Member

    Messages:
    13,843
    Likes Received:
    65
    Trophy Points:
    48
    Location:
    Massachusetts, Billerica
    0.2438Ins. = 8.732mm

    This Measurement is where MY Pilot Screws are set.

    The measurement is, ... How Deep, ... down into the Pilot Screw Borehole, ... the very TOP of the Pilot Mixture Screw is, ... from the TOP opening of the Hole. (The Top of the WINGS on either-side of the Slot).

    Hitachi's / Stock / 750cc / Midnite Max
     
    RickCoMatic, Jul 22, 2011
    #21
  2. skw1972

    skw1972 Member

    Messages:
    476
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Milton Florida
    dig it thanks man
     
    skw1972, Jul 22, 2011
    #22
  3. day7a1

    day7a1 Member

    Messages:
    623
    Likes Received:
    6
    Trophy Points:
    18
    Location:
    San Diego, CA
    RETRACTION!!!

    I just did some tuning...I guess I was missing the washer in the pilot needle hole, allowing the o-ring to get pushed out of the way when the needle was screwed all the way in.

    I now have all the depths the same at the same "turns from out" position.

    I used one of my wife's hair pins though...just bent the bottom to an L and broke off the top a the curve. It was perfect for getting the spring, washer, and o-ring out, as well as able to etch a line in the patina to mark the height. So now it's a MULTITOOL!
     
    day7a1, Jul 26, 2011
    #23
Page 2 of 2

Share This Page